Smittybilt SB76792 SRC JK Tubular front Doors - Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 W Artesia, Compton, CA 90220
Installation Instructions:
(Part # SB76792)
SRC JK Tubular Rear Doors
Revised 7.28.10
NOTE: Carefully read entire instructions thoroughly before attempting to install this part.
Step 1: Starting on the driver side of the vehicle, remove the (2) OE rear door hinge retain-
ing nuts.
Step 2: Slide the front seat forward to access the wiring hatch on the B pillar. Remove the
rectangular hatch to expose the rear door wiring plug.
NOTE: Some early year models may have a red safety catch on the wiring plug. Pull
the red catch out one click and depress the black engagement tongue to release.
Step 3: Open the rear door and unhook the door limit strap from the mount inside the B pil-
lar. New limit straps are provided in the kit.
Step 4: Carefully lift and remove the OE rear door from the vehicle.
Step 5: Install the supplied limit strap bracket (90-5868) onto the limit strap (769401).
Step 6: Slide the door hinges (93-5862 drvr and 93-5864 pass) into the OE mounting
brackets on the vehicle. Secure with the supplied 3/8” nuts.
Step 7: Carefully install the rear door assembly (93-8069 and 93-8073) onto the previously
installed hinges using the (4) supplied 3/8” X 1” stainless bolts and hardware from pack (90-
6738). Install the limit strap (769401) and bracket (90-5868) to the lower hinge bolts as well.
Leave the bolts snug only at this time.
Step 8: Carefully close the rear door and latch it to the door striker. Adjust the door striker
if the door won’t close properly.
INSTALLATION:
Parts Included Qty
93-8069 Driver Side Rear Door 1
93-8073 Passenger Side Rear Door 1
93-5862 Door Hinge 2
93-5864 Door Hinge 2
90-5868 Limit Strap Bracket 2
769401 Limit Strap 2
Parts Included Qty
90-6738 Hardware Pack: Tube Door 1
3/8” X 1” SS Button Head Bolt 12
3/8” Flat Washer 24
3/8” Nylock Nut 12
3/8” Hex Nut 4
90-6767 Hardware Pack: Tube Door 1
90-4264 Rubber Bumper 2