Smittybilt 76837 XRC Fender Flares - Manual

WWW.SMITTYBILT.COM
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
XRC Fender Flares
07-10 Wrangler & Unlimited
(Part # 76837)
Driver Side
Parts Included Qty Parts Included Qty
Driver Front Flare 1 Self-tapping Screw 10
Driver Rear Flare 1 10mm Hex Head Bolt 20
Passenger Front Flare 1 Flat Washer 40
Passenger Rear Flare 1 Lock-Nut 20
FRONT FLARE INSTALLATION
Step 1: Remove the five 10mm bolts holding the inner liner on. Four are visible, one is located towards the
back on top which you gain access to through a hole in the inner liner.
Step 2:
Disconnect the front turn signal plug.
Step 3:
Starting at the front of the factory flare and working your way towards the rear pull firmly outward
to disconnect the flare from the body of the vehicle. NOTE: You will here cracking/popping noise
this is from the clips snapping, which is normal. (They will not be re-used) After the flare and liner
are removed make sure to remove any plastic clips that may remain in the holes on the vehicle.
This can be done with a flat screwdriver or panel puller. Secure the turn signal wire behind the
body in a location where it does not interfere with anything.
Step 4:
Hold new flare up against body, lining up the holes in the flare with the holes in the body.
Loosely attach using 8 of the included 10mm bolts, 16 flat washers and 8 nuts. Position flare into
the best fitment and then securely tighten all hardware. (Fig A) Due to some variations in hole
locations on the vehicles you may need to slightly enlarge holes with a drill. Use caution when
drilling.
Note:
With some effort you can re-use the inner liners. This would require precise trimming and secure
with the previously removed hardware form Step 1 and some large O.D. flat washers.
REAR FLARE INSTALLATION
Step 5: Using a panel puller or flat head screwdriver remove the 5 black plastic plug fasteners from the
wheel-well area which hold on the inner liner.
Step 6:
Starting at the front of the factory flare and working your way towards the rear pull firmly outward
to disconnect the flare from the body of the vehicle. NOTE: You will here cracking/popping noise
this is from the clips snapping, which is normal. (They will not be re-used) After the flare and liner
are removed make sure to remove any plastic clips that may remain in the holes on the vehicle.
This can be done with a flat screwdriver or panel puller.
Read instructions entirely before installing this accessory.
WARNING: Check with Local and State laws before installing this accessory