Smittybilt 897xx Door Skins Pair - Manual

Installation Instructions
Door Skins Pair (#896xx,897xx)
1987-2006 Jeep Wrangler s
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Included Components:
1-Door Skin Driver Side
1-Door Skin Passenger Side
INSTALLATION INSTRUCTIONS:
THE TEMPERATURE SHOULD BE ABOVE 70 DEGREES FARENHEIT.
Before you begin, the temperature of the Door Skin should be above70 degrees Fahrenheit. We
suggest laying the door skin in the sunlight for 1 hour before installation. If you can’t install the Door
Skin in a 70 F (or warmer) environment, carefully use a hairdryer to warm the material. Installations
performed below 70 F can be difficult. They are designed to be a tight fit to eliminate any flapping and
A better fit.
NOTE: Instructions are configured for the driver side.
1. After removing skins from packaging, leave the Door Skins out in the sunlight for at least 1 hour.
2. Insert the frame into the upper rear corner of the door skin and then insert the Frame into the
upper front corner of the Door Skin. Press down the Velcro to secure the frame bar.
Driver Side Door Frame
(not included)
Driver Side Door Skin Door Skin Velcro Open