Smittybilt 49903 Seat Adapter Bracket Kit - Manual

WWW.SMITTYBILT.COM
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Seat Adapter Bracket Kit
03-06 Wrangler (Part # 49902) Driver Side
03-06 Wrangler (Part # 49903) Pass. Side
Parts Included Qty Parts Included Qty
Spacer 4 Threaded Rod 4
Flat Washer 4 Nylon Ring (49903) 2
Lock-Nut 4 Lever (49903) 1
Seat Belt Bracket 1
Step 1: Remove the 4 bolts (3-Hex, 1-Torx) that hold the seat riser to the floor.
Step 2: In order to remove the seat from the riser you need to unhook the two cables on the inside of the
seat. The bottom cable pulls off, the other cable may need to have some tension relieved on it in
order to detach. You can do this by pushing the lever backwards. The driver side should only have
a seat belt sensor wire that can be disconnect by unplugging it underneath the seat.
Step 3: Remove the cables from the cable bracket on the inside rear section on the passenger seat.
Step 4: Remove the female end seat belt and bracket from the rear inside of the seats. (Save the bolt, it will
be used later)
Step 5: To remove the seat from the riser, you will need to remove the two front and two rear side bolts that
attach to the seat cushion Now you can gain access and remove the bolts that hold the seat to the
riser.
Step 6: Remove the cable with the black end completely that you disconnected from the rear side bracket on
the passenger side in Step 3.
Step 7: Re-route the other cable with the white end to the opposite side on the passenger side bracket.
(from right to left side) (Fig A)
Step 8: Install the four 8mm threaded studs into the factory seat riser. (The short end of the stud goes into
the riser) (Fig B)
Step 9: DRIVER SIDE- place three spacers over the threaded rods and the seat belt bracket (threaded hole
on top) on the rear inner rod.(Fig C,E)
PASSENGER SIDE- place three spacers over the threaded rods and the seat belt bracket (threaded
hole on top) on the rear inner rod. On the rear outer rod, you will place a spacer, the one nylon ring
then the tilt lever and the second nylon ring. (Fig C, D, E) Connect tilt cable to end hole in lever.
NOTE: Carefully read entire instructions and product information thoroughly before
attempting to install/use this part.