Smittybilt 76635 SRC Classic Sides - Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
SRC Classic Sides (Part # 76635)
07-10 Jeep Wrangler (2-Door)
Parts Included Qty Parts Included Qty
Driver Side Bar 1 10 x 25mm Hex Bolt 4
Passenger Side Bar 1 10mm Flat Washer 4
Nut-Clip 4 6mm Flat Washer 8
6mm Ny-lock Nut 8
Step 1: Remove oem or aftermarket side rails/steps if equipped. (Fig A)
Step 2: Identify the passenger and driver side.(The short end goes towards the front) Place
the passenger side guard onto the vehicle by lining up the 4 tabs (2 front and 2 back)
on the guard with the already existing holes on the pinch weld area of your vehicle.
(Fig A)
Step 3: Identify the two holes (one front and one back) on the bottom of the body that the
Nut-clips will be inserted into by where the top brackets align with. (You may need to
remove some tape that is applied from the factory that is covering the holes)
Fig B,C,D
(Fig A) (Fig B)
Step 4: Loosely attach the guard to the vehicle by inserting the 2-10mm hex bolts into the
nut clips and 6mm lock-nuts onto the bracket studs that go through the pinch weld
area. (Fig D) Once you have attached the front and rear bolts and nuts, you may tighten
completely. Installation is now complete, proceed to other side and follow same steps.
(Fig E)
NOTE: Carefully read entire instructions thoroughly before attempting to install this part.
Line up the 4 tabs (2 front and 2 back) on
the guard with the already existing holes
on the pinch weld area of your vehicle.
You may need to remove some tape that is
applied from the factory that is covering the
holes. (Front passenger side pictured)