Smittybilt JN46 Side Bars - Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 1600 Walnut Parkway, Rancho Dominguez, CA 90220
Installation Instructions
Side Bars (JN40, 41, 44, 46)
1976-06 Jeep CJ’s and Wrangler
NOTE: Carefully read entire instructions thoroughly before
attempting to install this part. Drilling is required.
Parts Included Qty Tools Needed
Driver Side Bar 1 Drill
Passenger Side Bar 1 5/16” Drill Bit
10 MM Self Tapping Bolts 16 Ratchet and Socket Set
Step 1: Identify the Driver and Passenger bars. The longer side goes towards the front of the vehicle.
Note: For ease of installation it is recommended to have assistance during the install process.
Step2: Position the bar up against the vehicle frame. Maintain a minimum of ½ inch between the bottom of
the body and the top of the bar. (Figure A) Position the bar making sure it is parallel with the vehicle
frame while also making sure its parallel with the vehicle body. (Figure B)
Keep a minimum
of ½: between bar
and the body.
Position the bar so
that it is parallel
with the vehicle
body.
Passenger Side
Bar
Driver Side Bar
(Figure A) (Figure B)