Smittybilt JN49-S4x Sure-Step - Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 1600 Walnut Parkway, Compton, CA 90220
Installation Instructions
Sure-Step (Part # JN49-S4x)
2007 Jeep Unlimited (4 Door)
NOTE: Carefully read entire instructions thoroughly before
attempting to install this part. No drilling is required.
Parts Included Qty Parts Included Qty
Driver Side Bar 1 M6x25mm Button Head Bolts 12
Passenger Side Bar 1 M6x22mmx3mm Flat Washers 24
Front Brackets (Dr/Pass) 2 M6 Nylon Lock Nuts 12
Middle Brackets (Dr/Pass) 2 M8x25mm Hex Head Bolts 12
Rear Brackets (Dr/Pass) 2 M8x35mm Hex Head Bolts 2
M10 Nut Plates 4 M8x25mmx3mm Flat Washers 2
M10x35mm Hex Head Bolts 4 M8x15mmX3mm Flat Washers 12
M10 Lock Washers 4 M8 Lock Washers 14
M10x30mmx3mm Flat Washers 4
STEP 1: Remove the factory steps or rocker guards if equipped with. Locate and set aside the front, center
and rear brackets for the driver side.. (FR-L, CTR-L, RR-L) Identify the driver and passenger side
bars. The long end of the bar goes towards the front of the vehicle.
(Fig A)