Smittybilt 581035 C-RES (Cargo Restraint System) - Manual

WWW.SMITTYBILT.COM
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
C-RES (Cargo Restraint System)
07-10 Unlimited (4-Door)
Part #581035
NOTE: You will need to have the following to install this part correctly.
1. Tailgate retaining bar and brackets.
Step 1: To avoid damage to your CRES It is recommended to remove your soft top to install
this product.Remove your existing soft top at this time (If equipped)
Step 2: Unfold the C-RES top and lay it our over the rear of the vehicle. (Fig A)
Step 3: Starting on the driver side attach the plastic channel in the top into the front edge of
retaining channel the body tub next to the door opening. Then continue down the side
and around the rear corners. (Fig B) Repeat on the passenger side. If installing with the
OEM door surrounds continue to Step 4, if you are installing without the proceed to
Step 9.
(Fig A) (Fig B)
Step 4: Begin inserting the plastic channel in the top into the vertical part of the door surround
on the driver side. (Fig C)
Please read instructions entirely before installing this part
Unfold the C-RES top and lay it our
over the rear of the vehicle.
Step 3: Starting on the driver side attach the
plastic channel in the top into the front edge of
retaining channel the body tub next to the door
opening. Then continue down the side and
around the rear corners