Smittybilt 7010XX-7210XX Tonneau Cover - Manual

Installation Instructions
Tonneau Cover (#7010XX-7210XX)
1987-95 Jeep Wranglers
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton CA 90220
Before You Begin
Thank you for purchasing the Smittybilt Tonneau Cover for 87-95 Jeep Wrangler. Before you
get started, please read the important information listed below:
1. For this Tonneau Cover to fit correctly you must have Soft Top equipment, factory
installed hardware on your vehicle.
2. All Smittybilt Soft tops are pre-fit at the factory. Please note that in order to provide long
term fit, Smittybilt designs each top to fit very tight on the initial installation. Please
make sure it is at least 70 degrees F. when you first install this top or it will be very
difficult to install. If you use a hair dryer to warm the fabric, the install will be easier.
3. The Tonneau Cover may seem wrinkled when first installed, this is caused by the fabric
becoming wrinkled during shipping. The fabric and the wrinkles will relax after a few
days installed on the vehicle.
IF YOU HAVE ANY PROBLEMS WITH THE INSTALLATION OR PERFORMANCE OF THIS
TONNEAU COVER , DO NOT RETURN THE PRODUCT TO THE RETAILER. PLEASE CALL
909-272- 3176 FOR INSTALLATION HELP. FACTORY TRAINED PERSONNEL WILL BE
ABLE TO WALK YOU THROUGH THE INSTALLATION/PROBLEM.
Installation Instructions
1. Before installing the Tonneau, remove the original plastic pin (supplied by Jeep®) from the hole of
the factory soft-top bow assembly slider track. This will allow the bow assembly to move forward
for proper installation and fitting of the Tonneau cover (Figures 1 and 2).
Included Components:
1-Tonneau Cover
Figure 2
Warning: this top is designed to protect you from the elements only and is not designed
to keep you inside the vehicle in the event of an accident. Always fasten your seat belt.
!
Figure 1