Smittybilt JB48-F FRONT BUMPER - Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 1600 Walnut Parkway, Rancho Dominguez, CA 90220
Installation Instructions
FRONT BUMPER (Part # JB48-F)
07 JEEP WRANGLER JK
PARTS LIST
1
Front Bumper
2 Brackets
8 12MM X 35MM bolts
8 12MM nylon lock nuts
16 12MM washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY.
2. Unplug the bumper lights electrical connections (Fig 1)
3. Remove front factory bumper by removing the eight mounting bolts with a 17MM socket
wrench (Fig 1)
4. Install the new bumper brackets as shown in photos. Note that the bracket faces rearward
and the forward facing holes (those the mounts bolt onto the frame) are horizontal, and those
the bumper mounts to are vertical. (Fig 2)
5. Install the 12MM bolts and locking nuts to the mounts but leave finger tight to allow for
adjustment
6. Install the 12MM bolts and locking nuts to the bumper and the mount.
7. Adjust the bumper and tighten all the bolts. (Fig 3)
Fig 1
Bumper light plug
Four mounting bolts
per side