Smittybilt 76655 XRC Rear Bumper - Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
XRC Rear Bumper
(Part# 76655)
07-08 Jeep Wrangler (JK)
Parts Included Qty Parts Included Qty
XRC Rear Bumper 1
½” Flat Washer (USS) 8
Nut Plate 2 ½” Flat Washer (SAE) 4
½”-13 x 4 ½” Hex Bolt 4
½” Lock Nut 4
½”-13 x 1 ¼” Hex Bolt 4
Step 1: Remove the factory rear bumper and support brackets from the vehicle.
Step 2: Drill out the four holes in the center of the frame to ½”. ( Fig A)
(Fig A) (Fig B)
Step 3: Insert nut plate into the inside of the rear frame rails lining up the nuts in the plate with the holes
in the frame rail. (Fig B)
Step 4: Position the rear bumper up into place, aligning the four holes in the center of the frame with the
holes on the hitch plate portion of the bumper. (Fig D) (This step may require assistance) Attach
using the supplied ½”x 4 ½” bolts with flat washers and lock nuts. Do not completely tighten
at this time.
NOTE: Carefully read entire instructions before installing this product. It is recommend
having assistance for ease of installation.
Drill out the four existing holes in
the center of the frame to ½”.