Smittybilt SB2804 Winch Plate - Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 1600 Walnut Parkway, Compton, CA 90220
Revised 8.4.10
Installation Instructions:
Winch Plate (Part# SB2804)
2007-2010 Jeep JK
STEP 1: Unbolt and remove the factory front bumper and hardware from the vehicle.
NOTE: Be sure to unclip the factory fog light wiring harnesses if equipped
STEP 2: Loosely assemble the (3) main parts (92-7058 winch plate, 92-7061 frame mount
drvr and 92-7062 frame mount pass) using the supplied (6) 1/2” X 1 1/4” bolts and
hardware. Fig. A & B
STEP 3: Slide the unit into place between the frame rails. Align the front bolt holes and
clamp the assembly in place. Fig. A & B
STEP 4: Insert the supplied (4) 1/2” X 1” bolts and hardware in the lower frame mount
holes. Fig. A & B
Installation:
NOTE: Carefully read entire instructions thoroughly before attempting to assemble and/or
install this product. These steps are in conjunction with vehicles with the O.E.M. front
bumper. Similar steps can be used with other after-market bumpers.
Parts Included: Qty
92-7058 Winch Plate 1
92-7061 Frame Mount: Drvr 1
92-7062 Frame Mount: Pass 1
90-6779 Hardware Pack: Winch Plate 1
1/2” X 1” Hex Bolt 4
1/2” X 1 1/4” Hex Bolt 6
1/2” Stover Nut 10
1/2” Hardened Flat Washer 20