Smittybilt 2811 Winch Cradle - Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Winch Cradle
Part # 2811
Parts Included Qty Parts Included Qty
Main Base Plate 1 10mm Ny-lock Nut 4
Gear Side Handle 1 10mm x 20mm Bolt 4
Motor Side Handle 1 Flat Washer 4
Step 1: Set main base plate on a flat surface. (Fig A)
Step 2: Install the gear box handle (Shorter handle) on the right side of the main base plate with the
included 10mm hardware. The base of the handle goes on the outside of the base plate. (Fig A)
Step 3: Install the motor side handle (Longer handle) on the left side of the main base plate with the
included 10mm hardware. The base of the handle goes on the outside of the base plate. (Fig A)
(Fig A) (Fig B)
Step 4: Depending on the brand and style of the winch you are mounting you may need to reverse the
bolts used on the handle and fairlead (Bolts going from inside toward the outside) in order for
them not to rub on your particular winch models uprights/legs. (Fig C)
Step 5: On some model winches that have the clutch lever on the end of the gear box instead of on top,
it may be necessary to switch the handles.(Attach the longer handle on the gear box side and
the shorter handle on the motor side)
Note: Read instructions entirely before assembling this product.
The base of the
handle goes on the
outside of the base
plate.