Snorkel MX19-sn8792-12899 V-2 - Manual (Page 5)

5
Figure 6: Blocking Elevating Assembly
Routine Service
Use the following table as a guide for routine
maintenance, refer to the Service Manual for
complete service instructions.
SERVICE OPERATION INTERVAL
Monthly 6 Months 2 Years
Daily or or or
50 Hrs. 250 Hrs. 1000 Hrs.
Clean entire work platform X
Check battery fluid level X
Charge batteries X
Check tires for damage X
Check hydraulic fluid level X
Check for peeling, faded or X
missing labels & replace
Check deck and guardrail X
fasteners for proper torque
Inspect elevating assembly X
for bends or cracks
Check for & repair collision X
damage
Check emergency lowering X
valve operation
Check electric motor X
brushes
Check pivot pin retaining rings X
Change hydraulic filter X
Check all fasteners for X
proper torque
Change hydraulic fluid X
Scissor Brace
Installed
Stowed Position
Maintenance
Never perform service on the work platform
in the Elevating Assembly area while the
platform is elevated without first blocking
the Elevating Assembly.
Blocking Elevating Assembly (Figure 6)
Installation
1. Park the work platform on firm level ground.
2. Verify Platform Emergency Stop Switch is ON.
3. Turn Chassis Key Switch to CHASSIS.
4. Position Chassis Lift Switch to UP and elevate
platform approximately 7 Ft. (2.1 m).
5. Rotate Scissor Brace to a verticle position.
6. Lower Platform until end of Scissor Arm Weld-
ment rests on Brace.
Storage
1. Slowly raise Platform from the Chassis Controls,
while holding Brace, until the end of the Scissor
Arm Weldment clears the Scissor Brace.
2. Rotate Scissor Brace forward to rest on Chassis.