Snorkel TL37-sn7000+V-2 - Manual (Page 9)

5
The UpRight TL37 is of the parallel linkage vertical boom design, mounted on
either a road towable trailer, or on industrial bogie chassis . The unique yet very
simple boom configuration gives the maximum safety and control ability combined
with a robust construction to withstand a heavy working environment.
The TL37 machine is designed for two man capacity with 215 kg S.W.L.
The machine incorporates a bottom boom with tie rod, a short vertical boom and a
top boom with tie rod. The TL37 has also an independent hydraulically operated
Flick-Out Boom and Rotating Cage for extra manoeuvrability.
The hydraulic system is of a fail-safe design throughout, with built-in hydraulic lock
valves on all the rams as a precaution against hose failure. The machine is
controlled by means of proportional manual lever operated valves. These valves are
located at both the base and in the cage, as standard.
Emergency lower valves are fitted as standard to allow the machine to be lowered
from the Base. Additionally, a hand pump is fitted in the cage for emergency
operation.
The hydraulically operated outriggers are fitted with load sensing interlocks, to
prevent the booms being raised without the outriggers being extended and under
load. An interlock prevents the hydraulic outriggers being accidentally retracted
while the booms are raised. A simple system of warning lights show the power is
on and each of the outriggers is under load.
Performance.
Maximum
Working Height 13.1 m
Maximum Working Outreach 5.9 m
Capacity (2-man working) 215 kg
Slewing Arc 700°
Airborne Noise Emissions (Battery) 70 dB(A)
(Engine) 100 dB(A)
(Diesel) 103 dB(A)
Construction Standards.
The machine complies fully with the requirements of the following EEC Directives:
Directive 98/37/EC, the ‘Machinery Directive’.
Directive 89/336/EEC, as amended – the ‘Electromagnetic Compatibility Directive’.
Directive 73/23/EEC, as amended – the ‘Low Voltage Directive’.
The machine is designed and tested in accordance with all relevant B.S.I. and
European Standards including EN280.
DESCRIPTION OF EQUIPMENT