Snorkel U Drive 25-sn1125+ - Manual

1
U Drive 25
Operator Manual
U Drive 25
SERIAL NUMBERS 1120 TO CURRENT
WARNING
All personnel shall carefully read, understand and follow all safety rules, operating
instructions and the Scaffold Industry Association's MANUAL OF RESPONSIBILITIES
before performing maintenance on or operating any UpRight aerial work platform.
SAFETY RULES
NEVER attempt to
push the UpRight
Lift with people or
materials on the
platform or with
the platform
elevated.
NEVER elevate
platform unless all
four (4) outriggers
have been properly
installed. All wheels
or screwjacks must be
in solid contact with a
firm surface before the
platform is elevated.
NEVER operate the machine
within ten feet of power lines.
THIS MACHINE IS NOT
INSULATED.
NEVER sit, climb, or stand on the
platform guardrails or midrail.
NEVER elevate platform
without first leveling the base.
Safety
Rules
and
Operating
Instructions
Safety
Rules
and
Operating
Instructions
MACHINE must be driven only on smooth level floor surface.
NEVER use ladders, planks or other devices to increase the height of the platform.
NEVER attach overhanging loads to the platform or increase the platform size.
NEVER elevate platform if it contains more than one person or more than rated load (see specifications back page).
LOOK up, down and around for overhead obstructions and electrical conductors.
NEVER change operating or safety systems.
NEVER use outriggers from one model on another model.
CLOSE and secure cage after entering platform.
INSPECT the machine thoroughly for cracked welds, loose or missing hardware, hydraulic leaks, damaged control
or power cables and loose wire connections.
NEVER use the machine as a freight or personnel elevator.
NEVER recharge battery near sparks or open flame. Batteries that are being charged emit highly explosive hydrogen
gas.
AFTER USE secure the work platform against unauthorized use by turning key switch off and removing key.
NEVER replace any component or part with anything other than original UpRight replacement parts without the
manufacturer's consent.
NEVER use machine as a welding ground. Welding ground must be attached to same structural element which is
being repaired.