Snorkel X Series-sn20000+ - Manual (Page 6)

Page 4 114110-000 X-Series - Operator Manual
Controls and Indicators
C ONTROLS AND I NDICATORS
The operator shall know the location of each control and indicator and have a thorough knowledge of the
function and operation of each before attempting to operate the unit.
Figure 2: Controls and Indicators
P
RE
-O
PERATION
S
AFETY
I
NSPECTION
NOTE: Carefully read, understand and follow all safety rules, operating instructions, labels, and the Scaffold
Industry Association’s MANUAL OF RESPONSIBILITIES of ANSI A92.6-1999. Perform the following
steps each day before use.
1. Open modules and inspect for damage, fluid leaks or missing parts.
2. Check the level of the hydraulic fluid with the platform fully lowered. See “Hydraulic Fluid” on page 15.
Add recommended hydraulic fluid if necessary. See “Specifications” on page 20.
3. Check that fluid level in the batteries is correct. See “Battery Maintenance” on page 15.
4. Verify that the batteries are charged.
5. Check that the A.C. extension cord has been disconnected from the charger plug.
6. Check that all guardrails are properly in place and secured.
7. Inspect the machine thoroughly for cracked welds, loose or missing hardware, hydraulic leaks, dam-
aged cables or hoses, loose wire connections and wheel bolts.
1
2
4 5
6
3
1 5 3 2 4
1. Circuit Breaker
2. Chassis Key Switch
3. Chassis Lift/Lower Switch
4. Chassis Emergency Stop Switch
5. Hour Meter/Voltage Indicator
1. Steering Switch
2. Interlock Switch (on front of Control
Handle)
3. Control Handle
4. Platform Emergency Stop Switch
5. Lift/Drive Selector Switch
6. Horn Button (optional)
Platform Controls
Chassis Controls