Snorkel X32-sn53100+ User Manual

Page 11

Advertising
background image

System Function Inspection

504165-002

Operation Manual

Page 7

S

YSTEM

F

UNCTION

I

NSPECTION

Refer to Figure 2 for the locations of various controls and indicators.

W A R N I N G

!

!

STAND CLEAR of the work platform while performing the following checks.

Before operating the work platform, survey the work area for surface hazards such as holes, drop-offs,
bumps and debris.

Check in ALL directions, including above the work platform, for obstructions and electrical conductors.

Protect the control console cable from possible damage while performing checks.

1. Move the machine, if necessary, to an unobstructed area to allow for full elevation.
2. Pull Chassis Emergency Stop Switch to the ON position.
3. Pull Platform Emergency Stop Switch to the ON position.
4. Turn and hold the Chassis Key Switch to the ON position. Push the Chassis Lift/Lower Switch to the UP

position and raise the platform approximately 2,1 m (7 feet).

BLOCK THE ELEVATING ASSEMBLY AS

DESCRIBED ON PAGE 9.

5. Visually inspect the elevating assembly, lift cylinder, cables, and hoses for cracked welds and structural

damage, loose hardware, hydraulic leaks, loose wire connections, and erratic operation. Check for miss-
ing or loose parts.

6. Verify that the Depression Mechanism Supports have rotated into position under the machine.

REMOVE

THE SCISSOR BRACE AS DESCRIBED ON page 13.

7. Push the Chassis Lift/Lower Switch to the UP position and fully elevate the platform.
8. Partially lower the platform by pushing Chassis Lift/Lower Switch to LOWER, and check for proper oper-

ation of the audible lowering alarm.

9. Open the Emergency Lowering Valve (see Figure 5) by pulling the knob out to check for proper opera-

tion. When the platform is lowered, release the knob.

10. Push the Chassis Emergency Stop Switch to check for proper operation. All machine functions should

be disabled. Pull out the Chassis Emergency Stop Switch to resume.

11. Check that the route is clear of obstacles (persons, obstructions, holes, and drop-offs, bumps and

debris), is level, and is capable of supporting the wheel loads.

12. Mount the platform and properly close the entrance.
13. Mount the platform and select DRIVE mode.

NOTE:

Use both HI and LOW drive (if applicable) when performing the following step.

14. While engaging the Interlock Switch, move the Control Handle to FORWARD, then REVERSE, to check

for speed control.

15. Push the Steering Switch RIGHT, then LEFT, to check for steering control.
16. Select LIFT mode. Grasp the Control Handle, engaging the Interlock Switch, and push it forward to

check platform lift controls. Raise the platform to full elevation.

17. Pull back on the Control Handle. The platform should descend and the audible lowering alarm should

sound.

18. Push the Platform Emergency Stop Switch to check for proper operation. All machine functions should

be disabled. Pull out the Platform Emergency Stop Switch to resume.

Advertising
This manual is related to the following products: