Snorkel XRT27 Electric-sn1000+ - Manual

Sa
f
e
t
y
Ru
le
s an
d
O
p
er
a
t
ing
In
st
r
u
c
t
ions
Saf
e
ty Rule
s and Opera
t
ing
Instruc
t
ions
WARNING
All personnel shall carefully read, understand and follow all safety rules,
operating instructions, and the Scaffold Industry Association’s MANUAL
OF RESPONSIBILITIES (ANSI A92.6) before operating or performing
maintenance on any UpRight Aerial Work Platform.
Operator Manual
Safety Rules
NEVER operate the machine without first surveying the work area for surface hazards such as holes,
drop-offs, bumps and debris.
NEVER operate the machine if all guardrails are not properly in place and secured with all fasteners prop-
erly torqued.
SECURE and lock gate after mounting platform.
NEVER use ladders or scaffolding on the platform.
NEVER attach overhanging loads or increase platform size.
LOOK up, down and around for overhead obstructions and electrical conductors.
DISTRIBUTE all loads evenly on the platform. See the back cover for maximum platform load.
NEVER use damaged equipment. (Contact UpRight for instructions. See toll-free phone number on back
cover)
NEVER change operating or safety systems.
INSPECT the machine thoroughly for cracked welds, loose hardware, hydraulic leaks, damaged control
cable, loose wire connections and wheel bolts.
NEVER climb down elevating assembly with the platform elevated.
NEVER perform service on machine while platform is elevated without blocking elevating assembly.
NEVER recharge battery near sparks or open flame; batteries that are being charged emit highly explo-
sive hydrogen gas.
AFTER USE secure the work platform against unauthorized use by turning key switch off and removing
key.
NEVER replace any component or part with anything other than original UpRight replacement parts with-
out the manufacturer’s consent.
NEVER elevate the platform or
drive the machine while elevated
unless the machine is on firm
level surface.
NEVER sit, stand or climb on
guardrail or midrail.
NEVER operate the machine
within ten feet of power lines.
THIS MACHINE IS NOT
INSULATED.
XRT Electric
SERIAL NO. 1000 to Current