Snorkel XRT33 Electric-sn1001+ User Manual
Page 5
5
XRT Electric
Figure 3: Platform Controls
26. Turn the Lift/Drive Switch to DRIVE.
NOTE: The Speed Range Selector Switch
has two positions: HIGH SPEED and
LOW SPEED. Perform Step 27 for each
speed.
27. Engage the Interlock Switch and slowly
push the Control Handle FORWARD, then
REVERSE, to check for proportional speed
control.
28. Push the Steering Switch RIGHT, then
LEFT, to check for steering control.
29. Turn the Lift/Drive Switch to LIFT.
30. Engage the Interlock Switch and slowly
push the Control Handle forward to check
the platform lift controls. Raise the platform
to full elevation.
31. Pull back on the Control Handle. The plat-
form should descend and the Audible Low-
ering Alarm should sound.
32. Lower the platform completely.
33. Push the Platform Emergency Stop button
to check for proper operation. All the
machine functions should be disabled. Pull
out the Platform Emergency Stop button to
resume.
34. Turn the Platform Controls key switch to
OFF.
35. Push the Platform Emergency Stop button
to the OFF position.
36. Dismount the platform.
37. Push the Chassis Emergency Stop button to
the OFF position.
LOW
BATTERY
MOTOR
TEMPERATURE
HIGH
SPEED
LOW
SPEED
LIFT
DRIVE
RAISE
FWD.
LOWER
REV.
EMERGENCY
STOP
EMERGENCY STOP
INTERLOCK SWITCH
STEERING SWITCH
CONTROL HANDLE
LIFT/DRIVE
SPEED SELECTOR
KEY SWITCH