Snorkel S3246 CE - Manual (Page 33)

Chapter 8 – Prestart Inspection
S2646/3246 – 0410063EE 29
Right Side
0361259 0371923
Rear
0074311
Rod end of lift cylinder(s)
0372000
Top of Chassis
0361259
0074311
451986
0371923
451986
0372000
DEATH OR SERIOUS INJURY CAN RESULT FROM TIPPING OVER.
TO KEEP FROM TIPPING THIS MACHINE OVER FOLLOW THESE RULES.
OTHER ACTIONS CAN ALSO CAUSE THIS MACHINE TO TIP OVER
NOTE: STUDY THE OPERATOR'S MANUAL
BEFORE OPERATING THIS MACHINE.
0372000
DO NOT
DO NOT
DO NOT
DO NOT
DO NOT override safety devices.
overload the machine.
stand or sit on guardrails.
attach ropes or chains to guardrails.
carry loads outside the railing or use
as a crane.
DO NOT use this machine without the railings and the
entry gate, chain or bar in place. You could
fall out and hurt or kill yourself.
DO NOT use this machine if it is not working right, or if
any part of it is damaged, worn, or missing.
An accident could cause injury or death.
DO NOT
DO NOT
let an untrained or unauthorized person use this
machine. When you leave the machine unattended,
remove the key, or turn off the battery switch on the base
of the machine and lock the battery switch in the off
position.
replace components critical to machine stability, such as
batteries and wheel equipment, with lighter weight or
non-factory approved substitutes.
DO NOT
DO NOT
DO NOT
ride platform while machine is on a truck, fork lift
or other device.
use ladder, scaffold, or other means to increase
size or platform height.
use with damaged tires or wheels.
DO NOT RAISE OR DRIVE AN ELEVATED
PLATFORM ON
SOFT OR UNEVEN
SURFACES
DO NOT RAISE OR DRIVE AN ELEVATED
PLATFORM ON A
SLOPE
GO NO CLOSER THAN 4 feet (1.2m)
to ANY DROP OFF
OR HOLE
4 FT
OK
1. 3. 2.
ALARM MEANS TIPOVER DANGER!
LOWER PLATFORM IMMEDIATELY TO AVOID
TIPOVER HAZARDS
USE ON
FLAT, LEVEL, AND
SOLID SURFACES
ONLY
4 FT
OK
ELECTRICAL SHOCK CAN KILL YOU
This machine is not electrically insulated. Maintain 10 feet minimum
clearance from electrical power lines and apparatus.
Allow for platform sway, rock, or sag. If voltage is 300 V to 50 kV stay at least
10 feet (3.1m) away. If voltage is more than 50 kV talk with your supervisor
or read the Operator's Manual on this machine for safe distances.
This machine will not protect you from shock.
DO NOT RAISE THE PLATFORM
IN WIND ABOVE 28 MPH (12.5 M/S)