Snorkel SR3084SL - Manual (Page 43)

Chapter 8 – Operation
SR3084SL – 8210037 39
4. At the front of the platform, remove the hardware
(nuts, bolts, spacer, washers etc.) from the corners
of the front guardrail. Refer to Figure 8.8.
Figure 8.8 – Platform
5. Fold the front guardrail inward so it rests on the plat-
form. Refer to Figure 8.9.
Rear Guardrail
Right
Guardrail
Front
Guardrail
Rear
Left Guardrail
Front
Figure 8.9 – Fold Down Guardrails
6. At the rear of the platform, close and latch the entry
gate and remove the hardware (nuts, bolts, spacer,
washers etc.) from the corners of the rear guardrail.
Refer to Figure 8.10.
Front Guardrail
Hardware
Front Guardrail
Hardware
Figure 8.10 – Lower Controls
7. Fold the rear guardrail inward so it rests on the plat-
form being careful to keep the entry gate latched.
Refer to Figure 8.9.
8. Lift up on the right guardrail and fold it inward so it
rests on the platform. Repeat with the left guardrail.
Refer to Figure 8.9.
If the guardrail will not fold down, loosen the
hardware at the bottom of the side guardrail.
Refer to Figure 8.10.
Use the following procedure to reassemble the guard-
rails before operating the aerial platform from the upper
controls:
1. Fully raise the right guardrail to the upright position
and push downward on the guardrail making sure it
securely sets into the platform. Repeat with the left
guardrail.
2. Fully raise the rear guardrail to the upright position,
being careful to keep the entry gate latched. Connect
the rear guardrail to the left and right guardrail by
reinstalling the hardware (nuts, bolts, spacer, wash-
ers etc.) to the corners of the guardrails and tighten
securely. Refer to Figure 8.10.
3. Fully raise the front guardrail to the upright position.
Connect the rear guardrail to the left and right guard-
rail by reinstalling the hardware (nuts, bolts, spacer,
washers etc.) to the corners of the guardrails and
tighten securely. Refer to Figure 8.8.
A
Warning
The potential for an accident increases from improp-
erly driving or steering the aerial platform. Death or
serious injury could result from such accidents. Make
sure the upper control panel is at the front right side
of the platform, hooked on the guardrail, and hanging
inside the platform.
y
Rear Guardrail
Hardware
Side Guardrail Hardware
Rear Guardrail
Hardware
Side Guardrail Hardware