Aries Automotive 4066-2 - Manual

INSTALLATION INSTRUCTIONS
4066/4066-2
2007 CADILLAC ESCALADE GRILL/BRUSH GUARD
HARDWARE KIT:
(1) GRILL GUARD
(2) BRACKETS
(2) BOTTOM BRACKETS
(2) BOTTOM END BRACKETS
(10)M12 X 30mm HEX HEAD BOLTS
(24)M12 FLAT WASHERS
(12)M12 NYLOC HEX NUTS
(2) M12 X 120mm HEX HEAD BOLTS
(2) M6X 20 HEX HEAD BOLTS
PROCEDURE:
1- REMOVE CONTENTS FROM BOX AND CHECK FOR DAMAGE. VERIFY
ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY.
2- REMOVE (2) PLASTIC RETAINER TOWHOOK COVERS LOCATED AT
LOWER END OF FRONT BUMPER (PASSENGER SIDE SHOWN) SEE
FIG#1
3- INSTALL (1) BOTTOM BRACKET (1) BOTTOM END BRACKET USING (2)
M12 X 30mm HEX HEAD BOLTS (2) M12 NYLOC HEX NUT (4) M12 FLAT
WASHERS. THEN INSTALL (1) M12 X 120mm HEX HEAD BOLT (1) M12
NYLOC NUT (2) M12 FLAT WASHERS, ADJUST BOTTOM BRACKET
DOWN THEN TIGHTEN. (DRIVER SIDE SHOWN) SEE FIG.# 2
NOTE: FOR EXISTING TOWHOOKS. REMOVE (2) M12 X 30mm HEX
HEAD BOLTS (2) M12 NYLOC HEX HEAD NUTS (4) M12 FLAT
WASHERS FROM HARDWARE KIT AND USE EXISTING TOWHOOKS
AND HARD WARE FOR BOTTOM AND BOTTOM END BRACKET
INTALLATION.
4- REPEAT PROCEDURE #3 ON OPPOSITE SIDE.
5- INSTALL GRILL GUARD ON TO DRIVER AND PASSENGER BOTTOM
BRACKET ASSEMBLIES USING (6) M12 X 30 HEX HEAD BOLTS (6) M12
NYLOC NUTS (12) M12 FLAT WASHERS LEAVE LOOSE, SEE FIG. #2
(DRIVER SIDE SHOWN).
6- OPEN HOOD FOR ACCESS, REMOVE (2) EXISTING BOLTS LOCATED
INSIDE OF GRILL MOUNT AND SET ASIDE (DRIVER SIDE SHOWN) SEE
FIG #3. INSTALL DRIVER/PASSENGER TOP BRACKET USING EXISTING
BOLTS. THEN BOLT TOP BRACKETS (DRIVER/PASSENGER) ON TO