Aries Automotive 4047 - Manual

INSTALLATION INSTUCTIONS-4047
99-02 CHEVROLET SILVERADO ¾ TON/00-05 SUBURBAN ¾ TON
PARTS LIST
2 – Frame Brackets 2 – ¼” x 1 Cap Screws
2 – Brace Brackets 2 – ¼” Nylock Nuts
6 – 7/16” x 1-1/4” Hex Bolts 12 - 7/16” Flat washers
6 – 7/16” Hex Nuts
INSTALLING THE FRAME BRACKETS
Remove factory tow hooks from front section of vehicle.
Using the bolts that held the tow hooks in place (two bolts per hook) attach the mounting bracket
as per diagram below. Do not fasten too tightly to allow for adjustment.
INSTALLING THE FRONT BAR
Line up the two holes on the lower portion of the bar with the two holes in the frame brackets
(outer edge). Attach bar to the frame brackets using the 7/16” bolts and nuts. When you are
satisfied the bar is aligned, tighten the three bolts supporting the bar. Tighten the bolts holding
the frame brackets to the vehicle.
INSTALLING THE BRACE BRACKETS
Remove the three bumper mounting bolts from the front of the frame and the two side support
bracket bolts from each side of the vehicle. Lower the bumper until you can see the upper bolts
that secure the bumper to the bumper mounting bracket. Position large hole of the brace bracket
on upper bumper bolt. Replace bumper to its original position and position small hole of the brace
bracket to the middle plate of the guard. Adjust bracket bolts, replace bumper and tighten all
bolts.