Aries Automotive 5047 - Manual

INSTALLATION INSTRUCTIONS
GRILL/ BRUSH GUARD 5047
2004 DODGE DURANGO 2/4WD
PARTS LIST
(1) FRONT BAR
(12) 7/16” FLAT WASHERS
(2) FRAME MOUNT BRACKETS (6) 7/16” HEX LOCK NUTS
(2) BRACE BRACKETS, (2) TOP BRACKETS (2) 3/8 BUTTON BOLTS
(6) 7/16” x 1 1/4” HEX BOLTS (4) 3/8 NYLON LOCK NUTS
(2) 3/8 FLAT WASHERS (2) 3/8 X 1 ¼ HEX BOLT
(2) 3/8 SAE WASHERS
PROCEDURE
1. Start with passenger side frame bracket. Remove the 2 lower nuts holding the bumper frame to the
main frame and than attach frame brackets using the existing flance nuts.
2. Repeat for driver-side Frame Mount Bracket.
3. Attach top support L bracket to the existing flance nuts as shown
4. Repeat the above for the driver side
5. Attach top support bracket to the L bracket between bumper and grill using the 3/8 hex nut and SAE
washers.
6. Repeat above for driver side.
7. Line up the 3 holes on the lower portion of the Front Bar with the 3 holes of the Frame Mount Brackets
and attach using (3) 7/16” x 1 1/4” hex bolts, (6) 7/16” flat washers, and (3) 7/16” hex lock nuts for each
side. Hand tighten.
8. Proceed to attach top support brackets to the outer edge of front bumper up rights using the 3/8 x 1
button bolts.
9. Align front bar assembly with front of the vehicle and secure all fasteners.
SEE ILLUSTRATION BELOW