Aries Automotive 6054-2 - Manual

Page 1 of 3
PARTS LIST:
1 Grille Guard 2 10-1.50mm x 40mm Hex Bolts
1 Passenger Side Mounting Bracket 2 10-1.50mm x 25mm Hex Bolts
1 Driver Side Mounting Bracket 4 10mm x 30mm OD x 2.5mm Large Flat Washers
1 Passenger Side Top Bracket 8 10mm x 20mm OD x 2mm Flat Washers
1 Driver Side Top Bracket 2 10mm Lock Washers
4 12-1.75mm x 30mm Hex Bolts 4 10mm Nylon Lock Nuts
8 12mm x 32mm OD x 3mm Flat Washers 2 8-1.25mm x 25mm Hex Bolts
4 12mm Nylon Lock Nuts 4 8mm ID x 24mm OD x 2mm Flat Washers
2 10-1.5mm x 20mm x 70mm x 6mm Nut Plates 2 8mm Nylon Lock Nuts
2 10-1.50mm x 25mm Button Head Allen Bolts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY. ASSISTANCE IS RECOMMENDED. CUTTING IS REQUIRED.
2. Use a flat blade screwdriver to carefully remove all fasteners from the plastic cover on the top or the
radiator, between the radiator and the grille. Also remove the lower splash guard under the vehicle.
NOTE: Pay close attention to the type and location of all factory fasteners to make reinstallation easier.
Move the (2) plastic covers to clean, stable work area.
3. Select the driver side Frame Mounting Bracket and insert it into position above the cross member. Line
up the rear mounting hole with the factory hole in the frame and temporarily bolt the Bracket into
position with the included (1) 10mm x 25mm Hex Bolt, (2) 10mm x 20mm Flat Washers and (1) 10mm
Nylon Lock Nut, (Figure 1). Do not tighten hardware at this time. Line up the forward hole with the hole
in the lower radiator core support. Insert the (1) 10mm Nut plate in from behind the cross member and
line up the threaded hole with the hole in the cross member. Bolt the Bracket to the cross member with
the included (1) 10mm x 40mm Hex Bolt, (1) 10mm x 30mm OD Large Flat Washer and (1) 10mm Lock
Washer, (Figure 2). Repeat this step to install the passenger side Frame Bracket. Do not tighten
hardware at this time.
IMPORTANT: Before you thread the 10mm x 40mm Hex Bolt up into the Nut Plate, make sure
to check the length of the bolt. The bolt should measure no more than 40mm (1-
9/16”) from
the bottom of the head to the end of the bolt. If the bolt is longer than 40mm (1- 9/16”), do not
use and contact your local retailer. Do not attempt to install the bolt if it is longer than 40mm
(1-
9/16”), doing so will cause damage to the radiator. Use the 10mm x 30mm OD Large Flat
Washers to prevent Hex Bolt from coming in contact with radiator, (Figure 2).
Passenger Side Frame
Mounting Bracket Driver Side Frame
Mounting Bracket
Passenger Side Top
Mounting Bracket Driver Side Top
Mounting Bracket
INSTALLATION INSTRUCTIONS
2010 HONDA CRV
PART # 6054 / 6054-2