Aries Automotive 1050-2 - Manual

PARTS LIST:
Qty Description Qty Description
1 Aries Grill guard 10 12mm Lock washers
1 Driver/left mounting bracket 10 12mm Hex nuts
1 Passenger/right mounting bracket 2 10mm x 30mm Button Head Bolts
1 Driver/Left upper brace bracket 6 10mm Flat washers
1 Passenger/right upper brace bracket 3 10mm Lock washers
2 8mm x 30mm Rod bolts 2007-12 3 10mm Hex nuts
1 10mm x 50mm Rod bolt 2012 Driver side only 4 8mm Flat washers
10 12mm x 30mm Hex bolts 2 8mm Lock washers
20 12mm Flat washers 2 8mm Hex nut
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. CUTTING IS REQUIRED.
ASSISTANCE IS RECOMMENDED.
2. Start by removing front plastic splash shield from under the vehicle, using a flat tip screwdriver pry
and remove the plastic push pins holding the shield, as seen in (Fig 1 & 1A)
3. Once removed start to remove the top plastic fill plate between the bumper and the front grill there
are 2 push pins securing the plastic cover to the top of each frame rail, as seen in (Fig 2) with the
plastic push pins removed, remove the fill plate and place it & the splash shield on a clean, stable
work surface for trimming later.
4. Select the passenger/right side mounting bracket from the list of parts above, and secure it to the
bottom of the cross member with (1) 12mm x 30mm hex bolt, (2) 12mm flat washers, (1) 12mm
lock washer and (1) 12mm hex nut. NOTE: 07-09 models will use the outer mounting hole
location, seen in (Fig 3), 2010-12 models will use the inner mounting hole location, seen in
(Fig 3B). Secure the top of the bracket with (1) 12mm x 30mm hex bolt, (2) 12mm flat washers,
(1) 12mm lock washer and (1) 12mm hex nut through the upper tab on the side of the mounting
Page 1 of 5 01/20/12
Driver Top
Mounting
Bracket 07-11
Driver side Frame
Mounting Bracket Passenger side
Frame Mounting
Bracket
(2) 8mm Rod
Bolt
Passenger
Top Mounting
Bracket 07-12
INSTALLATION INSTRUCTIONS
2007-12 JEEP WRANGLER
PART# 1050 / 1050-2
(1) Driver side 10mm
Rod Bolt 2012
Driver Top
Mounting
Bracket 2012