Aries Automotive B35-5000 - Manual

BULL BAR
94-01 DODGE RAM
Page 1 of 2 3/30/10 Rev1(DP)
35-5000/B35-0000
PARTS LIST:
Qty Description Qty Description
1 Bull Bar 10 12mm Lock Washers
2 Frame Mounting Brackets 20 12mm x 32mm OD x 3mm Flat Washers
2 12-1.75mm x 100mm Hex Bolts 10 12-1.75mm Hex Nuts
8 12-1.75mm x 30mm Hex Bolts
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. CUTTING IS REQUIRED. ASSISTANCE IS
RECOMMENDED. It may be necessary to remove/relocate front license plate and license plate
bracket. It is not required, but strongly recommended. If local/state law requires a front license plate,
a license plate relocation kit is available.
1. Starting under the driver side of the front bumper, hold (1) Frame Mounting Bracket in
approximate position to determine the mounting location. Locate the (2) holes in the frame
between the body mount brackets. NOTE: Remove factory hex bolts (if supplied) and save for re-
installation. On some models, the hex nuts inside the frame rail may also need to be removed.
2. Bolt the Mounting Bracket into position with (2) 12mm x 30mm Hex Bolts, (4) 12mm Flat Washers,
(2) 12mm Lock Washers and (2) 12mm Hex Nuts in the top (2) mounting holes or use the factory
hardware removed in Step 1. Next, insert (1) 12mm x 100mm Hex Bolt, (2) 12mm Flat Washers,
(1) 12mm Lock Washer and (1) 12mm Hex Nut in the center mounting hole. Snug but do not
tighten hardware at this time. Repeat Steps 2 & 3 for passenger side Mounting Bracket
installation.
(2) 12mm x 30mm Hex Bolts
(4) 12mm Flat Washers
(2) 12mm Lock Washers
(2) 12mm Hex Nuts
(1) 12mm x 100mm Hex Bolt
(2) 12mm Flat Washers
(1) 12mm Lock Washer
(1) 12mm Hex Nut
Top Bolts (2) in Bracket
(2) 12mm x 30mm Hex Bolts
(4) 12mm Flat Washers
(2) 12mm Lock Washers
(2) 12mm Hex Nuts
(or use factory hardware if
equipped)