Aries Automotive B35-5007 - Manual

Page 1 of 3 2/11/11 (DP)
PARTS LIST:
1 Bull Bar
1 Driver/Left Side Frame Mounting Bracket
1 Passenger/Right Side Frame Mounting Bracket
8 10-1.5mm x 35mm Hex Bolts
12 10mm x 30mm OD x 2.5mm Flat Washers
8 10mm Lock Washers
4 10mm Hex Nuts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS RECOMMENDED.
2. Determine if the vehicle is equipped with, (Figure 1) or without factory tow hooks, (Figure 2). Remove
the plastic splash guard, (Figures 3 & 4). Pay close attention to the type and location of all factory
hardware for easier reinstallation. If vehicle is equipped with tow hooks, remove both tow hooks and
skip ahead to Step 3. NOTE: Tow hooks cannot be reinstalled with the Bull Bar.
a. On vehicles without factory tow hooks: Release the clips at the ends of the plastic bumper
cover that attach the lower cover to the upper cover. NOTE: It is not necessary to remove the
lower cover, only release the clips at the ends of the cover. Next, remove the (3) clips fastening
the air deflector to the bottom of the crossmember, (Figures 3 & 4). Pull the bumper cover
forward for access and pull the air deflector out from behind the bumper cover, (Figure 5).
Release the clips securing the (2) block off covers to the ends of the air deflector, (Figure 6).
Remove the (2) block offs. Reinstall the air deflector using the factory hardware. Reinstall the
bumper cover.
3. Select the driver side Frame Mounting Bracket. Line up the (2) slots in the bracket with the (2) threaded
holes in the bottom of the frame channel, (Figure 7). Bolt the Bracket to the frame channel with (2)
10mm x 35mm Hex Bolts, (2) 10mm Flat Washers and (2) 10mm Lock Washers, (Figure 8). Do not
tighten hardware at this time. Repeat this step for passenger side Frame Bracket installation.
IMPORTANT: This Bull Bar is not compatible with optional Adaptive Cruise Control-
Forward Collision Warning Systems featuring grille mounted laser control sensor.
Driver Side
Mounting Bracket
Passenger Side
Mounting Bracket
Complete Installation
INSTALLATION INSTRUCTIONS
2.5” BULL BAR PART # 35-5007/B35-5007
2011 DODGE DURANGO