Aries Automotive B35-3009 - Manual

1998-07 RANGER XLT / EDGE (3" OD)
BULL BAR PART# B35-3009 / 35-3009
1
ITEM
1
2,3
4
5
6
7
8
9
10
11
12
QTY
1
2
2
2
4
4
2
2
6
4
2
CONTENTS
Bull Bar Assembly
Bracket, Passenger (2) and Driver (3)
Mount Plate
Plastic Plug
Rubber Bumper
5/16-18 x 1.00” Self Tapping Screw
½-13 x 4.00” Hex Head Bolt
½-13 x 2.00” Hex Head Bolt
½” Flat Washer
½” Lock Washer
½-13 Hex Nut
STEP 1:
STEP 2:
STEP 3:
STEP 4:
Remove the contents from box and check for damage. Verify all parts are
present. Read instructions completely before beginning.
NOTE: It may be necessary to remove/relocate front license plate and
license plate bracket. It is not required, but strongly recommended. If
local/state laws require a license plate, license plate relocation kit 32-0055
is available.
If vehicle has a plastic shroud mounted to bottom of frame, remove bolts
with 10mm socket and remove “push-type” fasteners from shroud. Place
brackets against bottom of frame, reinstall plastic shroud with factory bolts
and replace “push-type” fasteners with 5/16” self tapping screws. Attach
brackets to outside face of frame members with ½” fasteners and mount
plate as shown.
Attach Bull Bar using ½” fasteners as shown. SEE FIGURE 1.
INSTALLTION INSTRUCTIONS
STEP 5: Level and adjust Bull Bar as desired and tighten all fasteners.
Recommended torque values are 64 Ft. Lbs. for ½” fasteners, 10 Ft. Lbs.
for 6mm fasteners, and 15 Ft. Lbs. for 5/16” fasteners.