Aries Automotive B35-4008 - Manual

INSTALLATION INSTRUCTIONS
BULL BAR PART# B35-4008 / 35-4008
1
1 Bull Bar 4 8-1.25mm x 25mm Hex Head Bolts
1 Driver/Left Frame Bracket (A) 4 8mm Lock Washers
1 Passenger/Right Frame Bracket (B) 4 8mm ID x 22mm OD x 3mm Flat Washers
2 1/2” x 1 ¼” Hex Head Bolts 2 1/2” Lock Washer
2 1/2” USS Flat Washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE
PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING
INSTALLATION.
2. NOTE: It may be necessary to remove/relocate front license plate and
license plate bracket. It is not required, but strongly recommended. If
local/state law requires a license plate, license plate relocation kit is
available.
3. From underside of vehicle, remove the two bolts holding the driver factory
tow hook, then remove tow hook from vehicle. NOTE: This Bull Bar is not
compatible with factory tow hooks, so you will not be reinstalling factory
tow hooks back onto vehicle.
4. Determine driver and passenger Frame Brackets. above for bracket.
Position driver side Frame Bracket to the inside of the frame rail and
secure using the included (2) 1/2” x 1 ¼” Hex Head Bolts, (2) 1/2” lock
Washer, and (4) 1/2” USS flat Washers (Fig 1). Do not tighten at this time.
5. Repeat steps 3&4 for passenger side Frame Bracket.
2007-10 SIERRA 1500
6. attach Bull Bar to Bull Bar Brackets using the included (4) 8mm x 25mm
Hex Head Bolts, (4) 8mm Lock Washers, and (4) 8mm Flat Washers (Fig
2). Do not tighten at this time.
7. Level and adjust Bull Bar, then tighten all hardware at this time. NOTE: If
you can’t reach the Bull Bar Bolts (8mm hardware) from behind of bumper
and though tow hook cavity,
8. Do periodic inspections to the installation to make sure that all hardware is
secure and tight.