Aries Automotive B35-9001 - Manual

2004-14 TITAN TRUCK / 2004-13 ARMADA
INSTRUCTION SHEET
QTY. ITEM CONTENT
1 1 BULL BAR
2 3 M12-1.25 X 60MM HEX HEAD BOLT
2 4 M12-1.25 X 30 MM HEX HEAD BOLT
4 5 ½” FLAT WASHER
4 6 ½” LOCK WASHER
2 7 M8-1.25 X 25MM HEX HEAD BOLT
4 8 3/8” FLAT WASHER
2 9 3/8 LOCK WASHER
2 10 SPACER TUBE
STEP 1 REMOVE CONTENTS FROM BOX AND VERIFY ALL PART ARE PRESENT. READ INSTRUCTIONS COMPLETELY BEFORE BEGINNING.
STEP 2 IT MAY BE NECESSARY TO REMOVE/RELOCATE FRONT LICENSE PLATE AND LICENSE PLATE BRACKET. IT IS NOT REQUIRED, BUT
SRONGLY RECOMMENDED.
STEP 3 REMOVE TOW HOOKS BY REMOVING FRONT AND REAR TOW HOOK BOLTS. BOLTS WILL BE TIGHT. NOTE: TOW HOOKS WILL NOT
BE REINSTALLED.
STEP 4 SLIDE BULL BAR ASSEMBLY THROUGH TOW HOOK OPENINGS AND ATTACH AS SHOWN. SEE FIGURE 2.
FINISH PROTECTION- ARIES PRODUCTS HAVE A HIGH FINISH THAT MUST BE MAINTAINED SUCH AS ANY OTHER HIGH FINISH PRODUCT
ON THE VEHICLE. PROTECT THE FINISH WITH A NON-ABRASIVE AUTOMOTIVE WAX. THE USE OF SOAP, POLISH, OR WAX THAT CONTAINS
ABRASIVES IS DETRIMENTAL, AS THE COMPOUNDS SCRATCH THE FINISH AND OPEN IT TO CORROSION.
DISCLAIMER- BUYER ASSUMES ALL RISK AND LIABILITY WHATSOEVER FROM THE INSTALLATION AND USE OF ARIES
PRODUCTS. ARIES PRODUCTS ARE SOLD AS DECORATIVE ACCESSORIES AND SHOULD NOT BE RELIED UPON AS
PROTECTION FOR THE VEHICLE OR OCCUPANTS IN THE EVENT OF A COLLISION OR ROLL OVER. ARIES AUTOMOTIVE
ASSUMES NO LIABILITY FOR INJURY, LOSS, INCIDENTAL OR CONSEQUENTIAL DAMAGES IN THE EVENT OF A COLLISION OR
ROLLOVER.
BULL BAR PART# B35-9001 / 35-9001
Remove existing tow hook and bolts