Aries Automotive B35-1003 User Manual

Installation instructions

Advertising
background image




PARTS LIST:

Qty Description

Qty

Description

1 Bull

Bar

4

10mm Lock Washers

1

Driver/Left Frame Mounting Bracket

8

10mm Flat Washers

1

Passenger/Right Frame Mounting

4

10mm Hex Nuts

4

10mm x 35mm Hex Bolts
















PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ

INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.

2. Start by removing front plastic skid shield from under the vehicle, using a flat tip screwdriver pry

the tabs out from the valance and remove the plastic push pins, the 3 bolts in front & the 1 bolt per
side of vehicle holding the side of the plastic skid shield in the wheel wheels followed by the bolts
securing the metal skid shield to vehicle towards the back of vehicle. As seen in (Fig 1 & 1A)
there is also a plastic insert to be removed; this plastic insert is tucked in and above the bottom lip
of the bumper this is to be removed to expose front bolts holding front of tow hook (Fig 2) shows
insert install (Fig 2A) shows plastic insert removed.

3. Once skid shield is removed, starting with the Driver/Left side you will need to remove the tow &

the tow hook housing as it is a two piece per side assembly, first locate and remove the large nut
on the back side of tow hook (Fig 3) shows nut, with the nut removed begin to remove the two
factory front bolts holding the front of the tow hook in place as seen in (Fig 3), tow hooks will slide
forward out from bumper NOTE: (tow hooks will not be reattached after bull bar mount brackets
are installed) with the tow hooks removed, remove the 2 bolts securing the tow hook housings to
the bottom of the frame. (Fig 4) shows tow hook housing bolts to be removed.

Page 1 of 3

INSTALLATION INSTRUCTIONS

2011 JEEP GRAND CHEROKEE

PART # B35-1003 / 35-1003

Passenger/Right

Side Frame

Mounting Bracket

Driver/Left

Side Frame

Mounting Bracket

Advertising