Aries Automotive B35-2001 - Manual

/ 2001-07 SEQUOIA 1999-06 TUNDRA
B35-2001 / 35-2001 INSTRUCTION SHEET
BULL BAR
QTY.
ITEM CONTENT
1 1 BULL BAR
2 2 BRACKETS-PASSENGER & DRIVER SIDE
4 3 RUBBER BUMPER
2 4 1/2 -13 X 2.00” HEX HEAD BOLT
4 5 ½” FLAT WASHERS
2 6 ½” LOCK WASHERS
2 7 M12-1.25 X 30MM HEX HEAD BOLT
STEP 1 REMOVE CONTENTS FROM BOX AND VERIFY ALL PART ARE PRESENT. READ INSTRUCTIONS COMPLETELY BEFORE BEGINNING.
STEP 2 IT MAY BE NECESSARY TO REMOVE/RELOCATE FRONT LICENSE PLATE AND LICENSE PLATE BRACKET. IT IS NOT REQUIRED, BUT
SRONGLY RECOMMENDED.
STEP 3 DETERMINE PASSENGER AND DRIVER BRACKETS. SEE FIGURE 1. REMOVE AND DISCARD TIE DOWN LOOP AND TOW HOOK, (SAVE
SHORTER 12MM FASTNERS). ATTACH BRACEKTS USING SHORTER EXISTING FASTENERS AND SUPPLIED 12MM BOLTS AS SHOWN. LEAVE
LOOSE.
STEP 4 ATTACH BULL BAR TO BRACKETS USING ½” FASTENERS AS SHOWN. LEVEL AND ADJUST BULL BAR AS DESIRED. TORQUE ALL
FASTENERS TO 65 FT.LBS.
FINISH PROTECTION- ARIES PRODUCTS HAVE A HIGH FINISH THAT MUST BE MAINTAINED SUCH AS ANY OTHER HIGH FINISH PRODUCT
ON THE VEHICLE. PROTECT THE FINISH WITH A NON-ABRASIVE AUTOMOTIVE WAX. THE USE OF SOAP, POLISH, OR WAX THAT CONTAINS
ABRASIVES IS DETRIMENTAL, AS THE COMPOUNDS SCRATCH THE FINISH AND OPEN IT TO CORROSION.
DISCLAIMER- BUYER ASSUMES ALL RISK AND LIABILITY WHATSOEVER FROM THE INSTALLATION AND USE OF ARIES
PRODUCTS. ARIES PRODUCTS ARE SOLD AS DECORATIVE ACCESSORIES AND SHOULD NOT BE RELIED UPON AS
PROTECTION FOR THE VEHICLE OR OCCUPANTS IN THE EVENT OF A COLLISION OR ROLL OVER. ARIES AUTOMOTIVE
ASSUMES NO LIABILITY FOR INJURY, LOSS, INCIDENTAL OR CONSEQUENTIAL DAMAGES IN THE EVENT OF A COLLISION OR
ROLLOVER.