Aries Automotive 205033-2 - Manual

PARTS LIST:
Qty Description Qty Description
1 Driver/Left Sidebar 4 12mm X 38mm OD x 3mm flat washers
1 Passenger/Right Sidebar 4 12mm x 40mm Bolt/10mm Nut Plates
1 Driver/Left Front Mounting Bracket 2 12mm x 40mm Bolt Plates
1 Passenger/Right Front Mounting Bracket 6 12mm x 32mm OD x 3mm Flat Washers
1 Driver/Left Front Support Bracket 6 12mm Lock Washers
1 Passenger/Right Front Support Bracket 6 12mm Hex Nuts
1 Driver/Left Rear Mounting Bracket 6 11mm Plastic Retainers
1 Passenger/Right Rear Mounting Bracket 4 10-1.50mm x 35mm Hex Bolts
4 12mm x 50mm Hex Bolts 4 10mm x 30mm OD x 2.5mm flat washers
4 12mm Lock Washers 4 10mm Lock Washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. Starting at the passenger side-front of the vehicle, remove the tape covering the factory oval
holes in the passenger side inner panel located by the front tire.
3. Next, partially thread a Plastic Retainer onto the threaded end of a Bolt and Nut Plate, (Fig
1B).
4. Once you have assembled the Plastic Retainer onto the Bolt and Nut Plate, insert the Bolt and
Nut Plate into the factory oval hole. Once the Bolt and Nut Plate is inserted, hold the Bolt end
with one hand and tighten the Plastic Retainer with your other hand. NOTE: Tighten the
Plastic Retainer until it reaches the side panel, (Fig 2).
5. Next, select (1) 12mm Bolt Plate and partially thread a Plastic Retainer onto it. Insert the Bolt
Plate into the oval hole and install in the forward, smaller oval hole as per step 4, (Fig 1A).
6. Select the passenger side front Mounting Bracket. Position the Mounting Bracket onto the
installed Bolt Plates. Secure it with (2) 12mm Flat Washers, (2) 12mm Lock Washers and (2)
12mm Hex Nuts, (Fig 3). Do not tighten at this time. Rotate the Bolt and Nut plate until the Nut
end lines up with the remaining hole in the Mounting Bracket and body. Thread (1) 10mm x
35mm Hex Bolt, (1) 10mm Flat Washer and (1) 10mm Lock Washer into the threaded nut.
Snug but do not tighten hardware at this time.
Page 1 of 3
INSTALLATION INSTRUCTIONS
09-13 DODGE RAM 1500 CREW CAB
10-13 DODGE RAM 2500 / 3500 CREW CAB
(EXCLUDES VECHILES WITH DIESEL EXHAUST FLUID SYSTEMS)
PART# 205033 / 205033-2
Passenger Side
Rear Mounting
Bracket
Passenger
Side Front
Mounting
Bracket
Driver Side Rear
Mounting
Bracket
Driver Side
Front
Mounting
Bracket
12mm x 40mm Bolt/10mm
Nut Plate (pictured with
Plastic Retainer installed
for example)
12mm x 40mm Bolt Plate
(pictured with Plastic
Retainer installed for
example)
Passenger Side Front
Support Bracket Driver Side Front
Support Bracket