Aries Automotive 203033-2 - Manual

1998-09 MAZDA B-SERIES P/U SUPER CAB
1998-09 RANGER EDGE SUPER CAB
Part # 203033 / 203033-2
1,2 2 STEP BAR, PASSENGER (1) AND DRIVER
3,4
11 2 1/2-13 X 2.50” HEX HEAD BOLT
12 2 1/2-13 X 2.00” HEX HEAD BOLT
13 4
14 4
15 10 3/8-16 X 1.25” HEX HEAD BOLT
16 16 3/8” FLAT WASHER
17 10 3/8” LOCK WASHER
18 6 3/8-16 HEX NUT
(2)
2 FRONT BRACKET, PASSENGER (3) AND DRIVER (4)
, PASSENGER (5) AND DRIVER (6)
7,8 2 MOUNT PLATE ASSEMBLY, PASSENGER (7) AND DRIVER (8)
, PASSENGER (9) AND DRIVER (10)
1/2” FLAT WASHER
1/2” LOCK WASHER
5,6 2 REAR BRACKET
9,10 2 SUPPORT BRACE
QTY CONTENTS - TOOLS -
3/4” SOCKET
9/16” SOCKET
9/16” WRENCH
*7/16” DRILL BIT
*DRILL
CENTER PUNCH
HAMMER
RATCHET
TORQUE WRENCH
*NOTE: A SHORT 7/16” BIT WITH A 3/8”
SHANK AND A SMALL OR RIGHT ANGLE
DRILL MAY BE NECESSARY FOR EASIER
INSTALLATION.
ITEM
3 5 7 9
4 6 8 10
REG. CAB
EXT. CAB
Remove the contents from box and check for damage. Verify all parts are present. Read instructions completely
before beginning.
Attach front brackets and support braces using 3/8” fasteners as shown.
Temporarily attach rear bracket to vehicle through hole as shown. Carefully cut out templates
and align with visible portion of rear bracket. Tape template in place and mark center of top hole with center
punch. Remove template and bracket from vehicle. Drill 7/16” diameter hole at this location.
If hole on rocker panel aligns with T-Slot on mount bracket fasten at this location. Drilling is not re-
quired.
Attach rear brackets to the backside of rocker panel using 3/8” fasteners as shown.
Attach step bars to brackets using 1/2” fasteners as shown.
Make sure step bar and brackets are properly aligned with vehicle and tighten fasteners. Recommended torque
value is 26 Ft. Lbs. for 3/8” fasteners and 64 Ft. Lbs. for 1/2” fasteners.
SEE FIGURES 1 THROUGH 3.
SEE FIGURE 4.
NOTE:
SEE FIGURE 5.
SEE FIGURE 6.
FINISH PROTECTION- ARIES PRODUCTS HAVE A HIGH FINISH THAT MUST BE MAINTAINED SUCH AS
ANY OTHER HIGH FINISH PRODUCT ON THE VEHICLE. PROTECT THE FINISH WITH A NON-ABRASIVE
AUTOMOTIVE WAX. THE USE OF SOAP, POLISH, OR WAX THAT CONTAINS ABRASIVES IS DETRIMENTAL,
AS THE COMPOUNDS SCRATCH THE FINISH AND OPEN IT TO CORROSION.
DISCLAIMER- BUYER ASSUMES ALL RISK AND LIABILITY WHATSOEVER FROM THE INSTALLATION
AND USE OF ARIES PRODUCTS. ARIES PRODUCTS ARE SOLD AS DECORATIVE ACCESSORIES AND
SHOULD NOT BE RELIED UPON AS PROTECTION FOR THE VEHICLE OR OCCUPANTS IN THE EVENT OF A
COLLISION OR ROLL OVER. ARIES AUTOMOTIVE ASSUMES NO LIABILITY FOR INJURY, LOSS.
Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Step 6.