Aries Automotive 207004-2 - Manual

Page 1 of 4 9/22/10 (DP)
INSTALLATION INSTRUCTION
SIDE BAR PART # 207004-2/207004
2010-11 2010-11 HYUNDAI TUCSON
PARTS LIST:
1 Driver/Left Sidebar 2 1/2" Lock Washers
1 Passenger/Right Sidebar 4 10-1.50mm x 30mm Hex Bolts
1 Driver/Left Front Mounting Bracket 8 10mm x 30mm OD x 2.5mm Flat Washers
1 Passenger/Right Front Mounting Bracket 8 10mm x 20mm OD x 2mm Flat Washers
1 Driver/Left Rear Mounting Bracket 12 10mm Lock Washers
1 Passenger/Right Rear Mounting Bracket 12 10mm Hex Nuts
1 Driver/Left Rear Support Bracket 4 8-1.25mm x 25mm Hex Bolts
1 Passenger/Right Rear Support Bracket 6 8mm x 24mm OD x 2mm Flat Washers
2 10-1.50mm x 40mm Double Bolt Plates 6 8mm Lock Washers
2 10-1.50mm x 40mm T-Bolt Plates 2 8mm Hex Nuts
2 10-1.50mm x 40mm Bolt Plates 2 6-1.0mm x 25mm Hex Bolts
2 8-1.25mm x 30mm Rod Bolts 2 6mm x 18mm OD x 1.6mm Flat Washers
2 1/2"-13 x 2" Hex Bolts 2 6mm Lock Washers
2 1/2" x 1-1/2" OD x 1/8" Flat Washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION.
2. Starting at the front, passenger side of the vehicle, locate the oval and round holes in the floor panel
next to the frame channel, (Figure 1). Remove any rubber plugs covering the two openings. Locate the
small 8mm hole in the floor. NOTE: The 8mm hole may be covered by sealant from the factory. Use a
small screwdriver to clean the sealant from the hole, (Figure 1).
3. Insert the long 8mm x 30mm Rod Bolt, (Figure 2), into the oval hole and out the smaller 8mm round
hole. Select (1) 10mm Double Bolt Plate and insert it into the oval hole and out the remaining round
hole, (Figure 2). Locate the Passenger Side Front Frame Bracket. Hang the bracket from the 8mm Rod
Passenger/Right
Side Rear
Mounting
Bracket
Passenger/Right
Side Rear
Support Bracket
Passenger/Right
Side Front
Mounting Bracket
Driver/Left Side
Rear Mounting
Bracket
Driver/Left Side
Rear Support
Bracket
Driver/Left Side
Front Mounting
Bracket
(2) 10mm x 40mm
Double Bolt Plates
(2) 10mm x 40mm
Bolt Plates
(2) 10mm x 40mm
T-Bolt Plates
(2) 8mm x 30mm
Rod Bolts