Aries Automotive 200104-2 - Manual

SIDEBAR
2011 KIA SPORTAGE
Page 1 of 4 1/11/11
(DP)
Part 200104/ 200104-2 ----PARTS LIST:
1 Driver/Left Sidebar 4 10-1.50mm x 30mm Hex Bolts
1 Passenger/Right Sidebar 8 10mm x 30mm OD x 2.5mm Flat Washers
1 Driver/Left Front Mounting Bracket 8 10mm x 20mm OD x 2mm Flat Washers
1 Passenger/Right Front Mounting Bracket 10 10mm Lock Washers
1 Driver/Left Rear Mounting Bracket 10 10mm Hex Nuts
1 Passenger/Right Rear Mounting Bracket 8 8-1.25mm x 25mm Hex Bolts
1 Driver/Left Rear Support Bracket 10 8mm x 24mm OD x 2mm Flat Washers
1 Passenger/Right Rear Support Bracket 10 8mm Lock Washers
2 10-1.50mm x 30mm Rounded Bolt Plates 2 8mm Hex Nuts
2 10-1.50mm x 40mm T-Bolt Plates 2 6-1.0mm x 25mm Hex Bolts
2 10-1.50mm x 40mm Bolt Plates 2 6mm x 18mm OD x 1.6mm Flat Washers
1 8-1.25mm x 30mm Driver Side Rod Bolt 2 6mm Lock Washers
1
8-1.25mm x 30mm Passenger Side Rod
Bolt
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION.
2. Starting at the front, driver side of the vehicle, locate the round hole in the backside of the body panel,
(Figure 1). NOTE: The hole will be covered by sealing tape and undercoating. Use a small screwdriver
to locate and remove the tape.
3. Remove the rubber plug covering the hole in the bottom of the body panel next to the pinch weld,
(Figure 2). Insert the driver side 8mm x 30mm Rod Bolt into the large hole in the bottom of the body
panel and out the smaller hole in the backside of the body panel identified in Step 2, (Figure 3).
4. Next, locate the oval slot in the bottom of the inner frame channel, (Figure 4A). Insert (1) 10mm x
30mm Rounded Bolt Plate into the frame channel, (Figure 4B). Select the driver side Front Frame
Bracket. Hang the bracket from the 8mm Rod Bolt with (1) 8mm Flat Washer, (1) 8mm Lock Washer
Passenger/Right
Side Rear
Mounting
Bracket
Passenger/Right
Side Rear
Support Bracket
Passenger/Right
Side Front
Mounting Bracket
Driver/Left
Side Rear
Mounting
Bracket
Driver/Left Side
Rear Support
Bracket
Driver/Left Side
Front Mounting
Bracket
(2) 10mm x 40mm Bolt Plates
(for Rear Brackets only)
(2) 10mm x 40mm T-Bolt Plates
(for Rear Brackets only)
(2) 10mm x 30mm Rounded
Bolt Plates (use on Front
Brackets only)
8mm x 30mm
Passenger/Right
Side Rod Bolt for
Front Bracket 8mm x 30mm
Driver/Left Side
Rod Bolt for
Front Bracket