Aries Automotive 202010-2 - Manual

2006-10 Toyota Rav4 –Part #202010
INSTALLATION INSTRUCTIONS
Hardware Kit: 4 EA. 1/2” X 2” Hex Bolt 2 EA. 3/8”X 1-1/2” Carriage Bolt 6 EA. Plastic Retainer Washer
4 EA. 1/2” Bolt Plate 2 EA. 3/8” Hex Nut 2 EA. Rectangular Washer
8 EA. 1/2” Flat washer 2 EA. 3/8” Flat washer 2 EA. Tube Spacer/Washer
8 EA. 1/2” Lockwasher 2 EA. 3/8” Lockwasher 4 EA. 1/2” Hex Nut
Bracket Kit: 1 EA. Front Mount Bracket, Driver Side 1 EA. Rear Mount Bracket, Driver Side
1 EA. Front Mount Bracket, Passngr Side 1 EA. Rear Mount Bracket, Passngr
Step 1: Study Illustrations below to familiarize your with the installation procedure before beginning installation.
Step 2: Attach rear mount bracket by inserting ½” bolt plate up into the hole in the floor and rotating bolt plate to lock. Slide plastic
retaining washer over thread and up against floorboard to hold bolt plate in place. Place rear bracket against bottom of floor as shown &
secure using ½ flat washer, lockwasher & nut. Hand-tighten only.
Step 3: Now attach front mount bracket to the floorboard using 1/2” bolt plate and 3/8” carriage bolt/ rectangular washer as shown
below. Turn bolt plate to lock into position and place plastic retainer washer over thread and push up to floorboard to hold in place.
Repeat with smaller 3/8” bolt/rectangular washer for innermost hole ( towards middle of vehicle ) and lock into position using plastic
washer. Hand-tighten only at this time.
Step 4: Repeat procedure on opposite side. Once completed periodically check all nuts and bolts for tightness.