Aries Automotive 233015-2 - Manual

INSTALLATION INSTRUCTION
Big Step Bar Part#233015-2/233015
2004-06 Ford F150 Crew Cab
QTY DESCRIPTION
1 Side Bar, left side
1 Side Bar, right side
1 hardware kit
NOTE: Please read this information before installing. Check components received with components listed
above. To obtain correct installation we recommend you to follow these step by step installation instructions
carefully. Please take care when installing this product to protect the finish and your investment.
Step One: Locate hardware and check contents with the hardware listed below.
QTY
DESCRIPTION
16 8mm x 32mm hex cap screw
8 8mm hex nut
24 8mm flat washer
16 8mm split lock washer
4 12mm x 50mm hex cap screw
4 12mm flat washer
4 12mm split lock washer
4 3”plastic rings, black
1 6L front support bracket, left side
1 6R front support bracket, right side
1 7L rear support bracket, left side
1 7R rear support bracket, right side
8 8mm nut clips
Step Two: Locate one 6L support bracket, four 8mm bolt, two 8mm nuts, six flat washers, two nut clips and Four
lock washers. Place nut clips in the two existing holes in the backside of the cab. Secure the brackets to the vehicle
as shown in Fig 1 using the hardware listed in this step. Do not fully tighten at this time
Step Three: Locate one 7L support bracket, four 8mm bolts, two 8mm nuts, six flat washers and four lock washers.
Place nut clips in the two existing holes in the backside of the cab. Secure the brackets to the vehicle as shown in
Fig 2. Do not fully tighten at this time