Aries Automotive 15600WRB - Manual

PARTS LIST:
Qty’s Description Qty’s Description
1 Winch receiver plate bracket 8 12mm Speed nuts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. Please
NOTE: This part is an addition to part # AL15600 & will be installed on your JK after
(Steps 3 to 8 have been completed on new installs. If your JK already has the AL15600
installed please remove it and then follow (Step 10 for 2007-11 model years.) or Step 13 for
model years 2012-14 NOTE: Cutting of the factory air pump bracket will need to be performed for
relocation & fitment of the 15600WRB for model years 2012-14 (Step 13 for reference)
3. Start by removing front plastic skid shield from under the vehicle, using a flat tip screwdriver pry and
remove the plastic push pins holding the skid shield, seen in (Fig 1 & 1A)
4. Once removed start to remove the top plastic cover there are 2 push pins holding the plastic cover
in front of the grill, as seen in (Fig 2) with the plastic push pins removed, slide the cover to the left
side to allow for access of the inner nuts holding the bumper onto vehicle, as seen in (Fig 3 & 3A),
once done continue to remove driver side by sliding plastic to the right side (Fig 4 & 4A) shows
location of nuts to be removed.
Page 1 of 6
INSTALLATION INSTRUCTIONS
2007-14 WRANGLER WINCH RECIEVER PLATE BRACKET FOR AL15600
PART # 15600WRB
Photo of parts shown for reference
Winch receiver plate