Aries Automotive 15910 - Manual

PARTS LIST:
Qty’s Description
Qty
’s
Description
1 Upper Base 10 8mm x 30mm Button Head Bolts
1 Driver/Side Pillar Bracket 2 8mm x 25mm Button Head Bolts
1 Passenger/Side Pillar Bracket 8 8mm x 16mm OD Flat Washers
1 5mm Allen Wrench 12 8mm Lock Washers
4 8mm x 24mm OD Flat Washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. Starting on the Passenger/Right side of the vehicle at the bottom of the windshield pillar, there are (5)
factory Torx bolts securing the hinge of the windshield to the vehicle (3) on the side & (2) in the front
remove only one side as seen in (Fig 1)
3. Once removed selected the Passengers/side pillar bracket from the list of parts above & begin to
install by attaching to vehicle with (3) 8mm x 30mm Button head bolts, (3) 8mm x 16mm OD flat
washers & (3) 8mm lock washers for the side as seen in (Fig 2) Snug but do not tighten hardware,
for the front of bracket secure with (2) 8mm x 30mm Button head bolts, (2) 8mm x 24mm OD flat
washers & (2) 8mm lock washers, as seen in (Fig 2A). Snug but do not tighten hardware
4. Once completed follow Step 2 -3 for the Driver side.
5. With both pillar mounting brackets installed to the vehicle select the Upper base from the list of
parts above and secure to the pillar brackets with (2) 8mm x 25mm Button head bolts, (2) 8mm x
16mm OD flat washers & (2) 8mm lock washers, as seen in (Fig 3 & 3A). Snug but do not tighten
hardware.
Page 1 of 2
INSTALLATION INSTRUCTIONS
2007-14 JK ROOF LIGHT BAR
PART # 15910
Upper Base
Passenger/Side Pillar bracket Driver/Side Pillar bracket