Aries Automotive 505555 - Manual

2012-13 FIAT SPORT SIDERAIL
PARTS LIST:
Qty Description Qty Description
1 Driver/Left Side Rail 4 10mm Flat Washer
1 Passenger/Right Side Rail 4 10mm Lock Washer
4 10mm x 38mm Bolt Plate 4 10mm Hex Nuts
4 Plastic retainers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. Starting by partially threading a Plastic Retainer onto the threaded end of (2) Bolt Plates, (Fig
1A) above shows one example.
3. With the bolt plates ready, Starting on the Passenger/right side front Insert the Bolt Plate into
the factory floorboard hole, located just under vehicles floor board behind front tire, Once the
Bolt Plate is inserted, hold the Bolt end with one hand and tighten the Plastic Retainer with
your other hand, NOTE: Tighten the Plastic Retainer until it reaches the floor panel. (Fig 2)
Shows Bolt Plate installed with out plastic retainer for view.
4. Next proceed with the passengers/right side rear you will need to first remove the (5) Hex bolts
holding the bottom lip of the plastic body kit along the rocker panel edge so you can bend it
down slightly to expose the (3) Philips head screws holding the black plastic panel, covering
the mounting hole, (Fig 3) shows location of hex bolts. NOTE: do not remove body kit.
Page 1 of 3 12/19/2011)
INSTALLATION INSTRUCTIONS
PART# B505555 / 505555
Passenger right Side rail
Driver left Side rail
10mm x 38mm Bolt Plate
(pictured with Plastic
Retainer installed for
example)
Fig 1A
Front of Vehicle