Aries Automotive 75-0000 - Manual

PARTS LIST:
Qty Description Qty Description
1 Mount Bracket 1 8mm x 20mm Hex Bolt
1 License plate X holder 1 8mm Lock Washer
6 6mm x 25mm Hex Bolt 1 8mm Hex Nut
12 6mm Flat Washer 2 8mm Flat Washer
6 6mm lock washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. Begin installation by removing License plate & factory holder (if equipped)
3. Once removed begin installation by locating & removing the 2 factory bolts just under the
front bumper lip on passenger right side vehicle (Fig 1) shows location of factory bolts.
4. With these two bolts removed select the Mount Bracket above and secure to the bumper lip
with the (2) 6mm x 25mm Hex bolts & (2) 6mm flat washers & (2) 6mm lock washers as
seen in (Fig 2). Snug but do not tighten hardware at this time.
5. Attach and secure the License plate X holder to the mount bracket you have just installed
with the (1) 8mm x 20mm Hex bolt, (2) 8mm flat washers, (1) 8mm lock washer & (1) 8mm
Hex nut Note: there are 3 holes for various position for you to choose, when you have
selected to which hole you will use tighten all hardware.
Page 1 of 2 12/2/2011
INSTALLATION INSTRUCTIONS
2011/2012 Fiat License Plate Relocator
Part # 75-0000
Mounting Brackets
License plate X holder