Rear wire guard (wwii), For panel fans, Cleaning propellers – Aerovent IM-110 User Manual

Page 4: Care and maintenance

Advertising
background image

Rear Wire Guard (WWII)

(Motorside)

For Panel Fans

PARTS
(1) Rear Panel

(4) Side Panels

(16) or (24) Hex Head Locknuts

(16) or (24)

5

16

" x 1" Hex Head Capscrews

(32) or (48)

3

8

" I.D. Flat Washers

ASSEMBLY
1. Bolt three sides of guard to rear panel using

5

16

" capscrews, nuts and flat washers.

2. Bolt partially assembled guard to panel fan

using capscrews, nuts and flat washers.

3. Arrange for electrical hook-up to fan motor. Two

methods may be used:

a. Drill out hole in fan panel and route wire or

conduit through opening.

Round Motorside Basket Guard

– OR –

b. Bend or cut side panel wire guard and route

wire or conduit through opening.

4. Assemble fourth side to guard and panel, slid-

ing along conduit or wiring if routing through

guard.

5. Securely tighten all locknuts.

Cleaning Propellers

The propeller in an axial flow fan must be kept

reasonably clean if it is to perform properly. Fans

handling fresh air for ventilating purposes will sel-

dom need cleaning. Fans exhausting process air

should be cleaned as required. Dirt or chemical

deposits will usually build up on a propeller evenly

and they present no problem to performance or

operation until they become thick enough to break

away in crust-like pieces. When this happens, the

propeller may be thrown out of balance and the

resulting vibration could be serious. Accumula-tions

of deposits should be removed by solvent cleaning

or scraping. If the propeller has been coated, be

careful not to cut through the protective covering.

Care and Maintenance

Regular and systematic inspection of all fan

parts is a necessity for good fan maintenance.

A general installation and maintenance bro-

chure (IM 100) has been supplied with this

shipment. It includes fan and motor bear-

ing lubrication, care and replacement of V-belt

drives and taperlock bushing instructions.

CAUTION: Recommended distance between fan blade and

shutter is approximately equal to

1

3

of the fan’s diameter.

4MWG06/11

Attach

Guard

To Wall

4 Mounting

Holes

Ring Fan

Basket Guard

www.aerovent.com

5959 trenton Lane n | minneapolis, mn 55442 | Phone: 763-551-7500 | Fax: 763-551-7501

®

Advertising