Advance Adapters 712514-T98 - Manual

ADVANCE ADAPTERS INC. P/N: 712514-T98
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 2
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 11-05-12
KIT CONSISTS OF:
No. Qty Part No. Description
OPTIONAL ITEMS:
Qty Part No. Description
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will void
any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend that
you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service
manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships
and parts stores.
1 716177 CLUTCH REL. ARM
JEEP T98 4 SPEED TRANSMISSION TO
FORD V8 ENGINES 1965 & UP
INSTALLATION INSTRUCTIONS:
This kit is designed for a T98 transmission. The kit includes a new T18 input shaft tht must be installed into the T98
transmission and we have included a special needle bearing to fit to the T98 main output shaft. The T98 transmission
also used two sizes of shifter synchronizer rings. If the transmission you have has a synchronizer ring that is too large,
you will then be required to purchase P/N T87-D14 from your Border Auto Parts 619-461-0171.
1. Install new shaft with needle bearings.
2. Install pilot bushing into the engine crank shaft.
3. Bolt the bearing retainer to the adapter plate using the 4 bolts supplied.
4. Install the new oil seal with the open side towards the transmission and make sure that it locates directly over the
transmission into the adapter. New bolts have been provided to go through both the transmission and adapter plate
and thread into the new bellhousing.
5. Place the adapter plate to the bellhousing, apply RTV silicone on the adapter plate and then index the transmission
into the adapter. New bolts have been provided to go through both the transmission and adapter plate and thread
into the new bellhousing.
6. The following Ford parts will be necessary:
Clutch Release Bearing
Clutch Release Lever
Pressure Plate
Clutch Disc with 1-1/16"-10 spline
Flywheel
Bellhousing with small index diameter of 4.686"
1. 1 711512 ADAPTER CASTING
2. 1 716016 TRANSMISSION INPUT SHAFT (17T)
3. 14 716043 NEEDLE BEARINGS FOR INPUT SHAFT
4. 1 716173 PILOT BEARING
5. 1 716724 C/R SEAL NO. 11734
6. 4 723119 S.H.C.S. 5/16"-18 x 1-1/4"
7. 2 724309 H.H.C.S. 7/16"-14 x 2" LONG
8. 1 761019 BEARING RETAINER
9. 1 JP001 JEEP INSTRUCTION MANUAL