Advance Adapters 712543 - Manual

KIT CONSISTS OF:
No. Qty Part No. Description
ADVANCE ADAPTERS INC. P/N: 712543
P.O. Box 247, 4320 Aerotech Center Way New Item: (7/99)
Paso Robles, CA 93447 PAGE 1 OF 3
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 09-09-11
OPTIONAL NOTES:
Wrangler & TJ's
If you have a master cylinder
that has a pin retaining the hose
assembly (pin type), you will need
Advance Adapters Part # 716130
or 716130TJ
(Identify which fit-
ting you will need - shown be-
low)
. This fitting goes on your
master cylinder and gives you a
#3 male flare fitting to couple to.
We also offer a new braided stain-
less steel hose with #3 fittings
on both ends. This hose is
P/N#
716130H.
1. 1 711543 ADAPTER PLATE
2. 1 716122 .750 PILOT BUSHING FOR LATE MODEL AX15
3. 1 716124 BRASS FITTING
4. 1 716153 .590 PILOT BUSHING FOR EARLY MODEL AX15
5. 1 716742 RETAINER SEAL
6. 9 720030 TRANSMISSION BOLTS - S.H.C.S.10mm x 1.25 x 40mm
7. 8 720040 RETAINER BOLTS - S.H.C.S. 8mm x 1.25 x 20mm
8. 4 723113 RETAINER BOLTS - S.H.C.S. 5/16"-18 x 7/8"
9. 4 724317 S.H.C.S. 7/16"-14 x 1-1/4" BOLTS
10. 1 761019 BEARING RETAINER - FORD 4.848"
NOTES:
This kit fits both the internal & external clutch release mechanisms on AX15 transmissions.
The F150 bellhousings from 1987-88 trucks should be used to best accommodate the new hydraulic clutch system.
Z & M Manufacturing offers a special slave cylinder bracket to assist in the installation of these bellhousings. The
Z & M bracket provides the adequate clearance for the Ford exhaust system.
Z & M's phone number is (408)-274-9011.
To fit the F150 truck slave cylinder to the Jeep master cylinder, we have included a brass fitting that, when installed
on your slave cylinder, provides a #3 male fitting. We offer a new stainless steel braided hose (
P/N #716130H )
that will couple your slave cylinder to your master cylinder. You can also purchase a generic hose assembly at
your local auto parts store. (See Optional Note above for YJ & TJ master cylinders).
CAUTION:
The input shaft pilot tip must be shortened 1/4"
to avoid bottoming out in the Ford crank.
AX15 TO FORD V8 ADAPTER
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications
to any of the components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be
required to complete your conversion, we strongly recommend that you contact our sales department for more information. This instruction sheet
is only to be used for the assembly of Advance Adapter components. We recommend that a service manual pertaining to your vehicle be obtained
for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships and parts
stores.
716130
716130TJ