Advance Adapters 712544 - Manual

KIT CONSISTS OF:
No. Qty Part No. Description
ADVANCE ADAPTERS INC. P/N: 712544
P.O. Box 247, 4320 Aerotech Center Way New Item: (04/01)
Paso Robles, CA 93447 PAGE 1 OF 2
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 12-18-01
1. 1 711544 ADAPTER PLATE
2. 1 716122 .750 PILOT BUSHING
3. 9 720030 TRANSMISSION BOLTS - S.H.C.S. 10mm x 1.25 x 30mm
4. 4 724317 S.H.C.S. 7/16"-14 x 1-1/4" BOLTS
5. 1 383735 11" x 1-1/8" 10 SPLINE CLUTCH DISC
CAUTION:
The input shaft pilot tip may need be shortened 1/4"
to avoid bottoming out in the Ford crank.
NV3550 TO FORD V8 ADAPTER
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications
to any of the components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will
be required to complete your conversion, we strongly recommend that you contact our sales department for more information. This instruction
sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service manual pertaining to your vehicle be obtained
for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships and parts
stores.
INSTALLATION PROCEDURES:
Set the adapter plate on the transmission so that it indexes on the dowel pins. The top two holes on the adapter
(for bolting to the bellhousing) require grinding on the transmission case to allow clearance for the bolts to be
installed.
Mark the transmission where the clearance must be
ground. Remove the adapter plate. With a disc grinder
(wearing the necessary safety glasses), grind the neces-
sary clearance for the bolt heads. Test fit if necessary.
A standard release bearing snout is 1.430". A standard
Ford pressure plate, release lever, and release bearing
should be used. A Chevy clutch disc is required.
(Centerforce #383735, or a stock Chevy 11" disc)