Advance Adapters 712562 - Manual

ADVANCE ADAPTERS INC. P/N: 712562
P.O. Box 247, 4320 Aerotech Center Way New Item: (01/07)
Paso Robles, CA 93447 PAGE 1 OF 1
Telephone: (800) 350-2223 Fax: (805) 238-4201 REV DATE: 04-19-10
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the
components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion,
we strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter
components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.
These manuals are normally available at automotive dealerships and parts stores.
KIT CONSITS OF:
No: Qty Part No. Description
R150 & R151 5 SPEED TRANSMISSION
TO THE 4 CYL. BELLHOUSING
1. 1 712562-B .590 PILOT BUSHING
2. 1 712563-PLT ADAPTER PLATE
3. 1 712562-RET T/O BEARING SNOUT
4. 2 716086 BELLHOUSING DOWEL PIN
5. 1 716742 SEAL
6. 15 720091 10mm-1.25 x 24mm S.H.C.S.
7. 2 720092 8mm-1.25 x 24mm S.H.C.S.
8. 4 723103 LOCKWASHER
9. 4 723113 5/16"-18 x 7/8" S.H.C.S.
INSTALLATION NOTES:
This new adapter has been designed to install a R150 & R151 to the 4 cylinder bellhousing.
This new transmission and adapter is 15mm longer than the stock setup. The rear crossmember mount must have the holes
slotted to compensate for the 15mm of extra length. The front and rear driveshafts should be checked for length and
modified when necessary.
ASSEMBLY PROCEDURES:
1. Remove the front bearing retainer from the new transmission and clean the front surface of the transmission.
2. Install the two new dowel pins into the adapter plate. The pins are a press fit.
3. With the R150/151 transmission on a work bench, apply a new, thin film of silicon to the transmission face where
the front retainer was just removed. Install the new adapter plate to the transmission. This adapter aligns to the front
input bearing of the R150/151 transmission. We have provided two clearance pockets on the adapter plate for the old
transmission dowel pins. Install the six 10mm bolts and the two 8mm bolts to retain the adapter plate.
4. Install the new seal into the new retainer snout. Then install the retainer onto the adapter plate make sure to apply silicone
around the retainer so that it seals to the adapter plate.
5. The stock 4 cylinder bellhousing should now be installed onto the adapter plate. Make sure the new dowel pins in the
plate align to the bellhousing.