Advance Adapters 712581 - Manual

ADVANCE ADAPTERS INC. P/N: 712581
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 1
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 04-24-01
KIT CONSISTS OF:
No. Qty Part No. Description
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components.
We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are
normally available at automotive dealerships and parts stores.
1. 1 712581-BLK BELLHOUSING
2. 1 716170 PILOT BEARING ( .590" )
3. 1 716176 GM THROW OUT LEVER
4. 1 716180 BALL PIVOT ( Installed )
5. 1 716338 CLUTCH RELEASE ARM BOOT
6. 6 723730 S.H.C.S. 3/8"-16 x 1-1/4" LONG
7. 1 JP001 JEEP INSTRUCTION MANUAL
BUICK BELLHOUSING FOR 4.686" INDEX
GM STOCK TRANSMISSIONS
INSTALLATION INSTRUCTIONS:
This bellhousing is basically a copy of the early Buick manual transmission design. The index diameter is for the smaller
car-type applications such as the Muncie, Saginaw and truck 4 speed SM420. The ball pivot installed in the bellhousing
is compatible with the GM forged steel design release arm. A slave cylinder can be adapted if necessary, but custom
fabrication for the bracket will be necessary for proper positioning. We would recommend the use of a Land Cruiser design,
A/A #716119.
DUST COVER INSTALLATION
Currently we do not have a dust cover for this application and you will need to use one from a Buick application and will
need to modify it accordingly. If your engine is 1986 or newer and used the large rear main seal, you will need to modify
the inside diameter of the steel sheet metal plate to allow for clearance around the rear main seal area.
CLUTCH INFORMATION:
CF360056 Pressure Plate 10-1/2"
383271 Clutch Disc 10-1/2"
CF700010 Flywheel 160TH
N1430 Throw Out Bearing